Operation Instructions
Parts Replacement
- 5 -
Figure 1
Figure 2
- 4 -
Electric motor replacement
Electric motor
mount
Electric motor mount
snap ring
5. Put the Drain Head (H) in the Tub Basin (B), and bolt the Drain Head (H) to Drain Hose
w/Hoop (I) securely
6. Lay both Plastic Floorboards (D) and Plastic Puppy Riser (E) into the Tub Basin.
1. Plug in the tub.
2. To bathe large breeds or older dogs, step on the down pedal to lower the tub and open the
front door. To bathe small breeds, step on the up pedal to raise the tub to a suitable level for
user’s stature (and/or by adding a booster rack).
3. Start then bath.
4. After the bath, let the water out of the tub and take the animal out.
5. Unplug the tub and clean it with a cloth.
1. Disconnect the powder cord from the wall socket. Remove the tabletop from the frame
assembly, and set it aside. Remove the grooming arm.
2. Disconnect the electric motor cable from the motor control unit. Remove the snap rings and
the retaining bolts that hold the electric motor to the frame assembly. (See Figure 1 and 2)
3. Using help, lift he frame assembly up, and remove the entire motor assembly from the
frame.
4. Install the new motor assembly in the reverse order. Reconnect the cable to the motor
control unit.
5. Plug the power cord into a wall socket and test the table for proper operation.
