Installation and Operation Manual
AENO
TM
electric blender
©
ASBISc Enterprises PLC. All rights reserved
Document version: 1.0.2, aeno.com
Page
7
of
47
•
for people with disabilities who are physically able to operate and
maintain the device in accordance with this user manual.
3.
Place the device on a dry and clean horizontal surface, making sure there is no
chance of tipping over. Never tilt the device while it is operating.
4.
Do not install the device near open flames, hot surfaces or heating appliances.
5.
Do not touch the bowl of the device during operation due to the possible
heating of its surface.
6.
Do not open the large lid of the bowl during the device's operation.
7.
Observe the minimum and maximum loading levels of the bowl of the device.
8.
Do not put sugar, legumes and tough fibrous plants (e.g. dill stems, parsley, raw
asparagus) in the bowl, as it can jam the blade and cause the device damage.
9.
Keep the minimum distance from other objects when operating the device (at
least 15 cm).
10.
Do not store the bowl in the refrigerator, as the resulting condensation can
short-circuit the electrical contacts.
11.
Do not touch the blades of the device with your hands to avoid cuts. Use the
supplied brush to clean the blades.
12.
Do not use the blender in areas with extreme temperature fluctuations, in
humid atmospheres, or where splashes of water, drops or condensation might
get on the electrical contacts of the blender base, to avoid fire and/or electric
shock.
13.
Before connecting the device to the mains, check that the rated voltage
indicated in the technical documentation corresponds to the electrical voltage
of the mains socket.
14.
Before turning on the device, make sure that the bowl is properly installed and
the lids are closed.
15.
Plug and unplug the power cable from the socket only with dry hands.
16.
Place the power cable so that it cannot be accidentally stepped on or hooked
on.
17.
Do not place the power cable on anything with a sharp edge and do not place
anything on the top of the cable.
18.
Make sure that the power cord does not hang over the edge of furniture or
touch surfaces that could damage the insulation.
19.
Do not wrap the power cord around the device.
20.
If the power cable is damaged, first de-energize the socket, then unplug the
device. The power cable should only be replaced by a service technician.
21.
Always unplug the power cable after using or cleaning the device.
22.
Use only those attachments, accessories, materials or replacement parts
recommended or supplied by ASBISc for this model.
