Aenera 1300 L, Warranty And Technical Manual For Installation, Use And Maintenance

Page: 12 / 40

Technical manual for installation, use and maintenance
12
ENG
5. METHOD OF USE OF CENTRAL VACUUM POWER UNIT
5.1 Use of the machine
Apply on the handle of the flexible tube the cleaning accessory suitable for the use you want to
achieve at that time.
Insert the other end of the flexible tube into the inlet valve, turning on the operation of the machine.
(See
FIG. D - page 5)
After use, remove the tube from the inlet valve verifying that the inlet valve is closed. Don’t close
automatically the inlet valve because it will make a strong coup against it. The machine needs a few
seconds before the end of the suction effect.
6. MAINTENANCE
Attention
BEFORE ANY MAINTENANCE ACTION IT IS REQUIRED TO DISCONNECT THE POWER CORD
FROM THE CURRENT, PLACE GLOVES AND MASKS FOR PROTECTION.
6.1 Maintenance indicated
Depending on the total time of use of the machine, some interventions are necessary for maintenance
to keep it functional and always avoid severe mechanical damage (see table).
Frequency*
(hours) Type of intervention Performed by
4 Cleaning the filter Owner
6 Empty dust container Owner
32 Filter replacement Owner
54 Verification obstruction in air
discharge Technical Assistance
400 Replacement of motor brushes
Technical Assistance
* It is usual consider that in normal use, the machine will be used on average 1
hour per week, so 4 hours to clean the filter, corresponds approximately to 1
month.
Clean periodically the body of the machine (outside) using a white cloth wet with water and mild soap.
Note: clean the machine with only water and mild soap. The use of alcohol or other solvents can
cause damage. Wait until completely dry before putting the machine into operation.
6.2 Dumping the container of the dust
Follow the following picture: (See FIG. E - page 5)
1 – Unmout the dust container;
2 – Remove the cone tab;
3 – Empty the dust container;
4 – Put the cone tab;