FlexProbe
®
- Flexible AC Current Probe
3
CHAPTER 1
INTRODUCTION
WARNING
•
Read the instruction manual completely and follow all the safety
information before attempting to use or service this instrument.
•
Wear protective clothing and gloves as required.
•
Use caution on any circuit: potentially high voltages and currents
may be present and may pose a shock hazard.
•
Read the safety specifications section prior to using the current
probe. Never exceed the maximum voltage ratings given.
•
Safety is the responsibility of the operator. The FlexProbe
®
must be
used only by qualified personnel using applicable safety precau
-
tions.
•
ALWAYS de-energize the circuit before wrapping the FlexProbe
®
around bare conductors, bus bars, or near live parts. Do not wrap on
live conductors.
•
ALWAYS connect the electronic module to the display device before
wrapping the FlexProbe
®
around the sample being tested.
•
ALWAYS inspect the module, sensor, sensor cable, and output termi
-
nals prior to use. Replace any defective parts immediately. Use only
factory parts.
•
NEVER use the FlexProbe
®
on electrical conductors rated above
1000V CAT III and 600V CAT IV.
1.1
International Electrical Symbols
This symbol signifies that the instrument is protected by double or reinforced
insulation.
This symbol on the instrument indicates a WARNING and that the operator must
refer to the user manual for instructions before operating the instrument. In this
manual, the symbol preceding instructions indicates that if the instructions are
not followed, bodily injury, installation/sample and product damage may result.
Risk of electric shock. The voltage at the parts marked with this symbol may be
dangerous.
This symbol refers to a type B current sensor. Do not apply around or remove from
HAZARDOUS LIVE conductors without additional protective means (de-energizing
the circuit or wearing protective clothing suitable for high voltage work).
In conformity with WEEE 2002/96/EC
www.
ShopAEMC
.com
Shop for AEMC products online at:
1.888.610.7664
