12
10/25/2016 - DOCUMENT NUMBER: 10-2500
© 2016 AEM Performance Electronics
AQ-1 DATA LOGGER
Input Mode - Engine Speed
·
Intended to log a "tachometer style" output
·
SIGNAL MUST BE A CLEAN DC SQUARE WAVE
OR DAMAGE TO THE LOGGER MAY OCCUR!!
·
The use of a tach adapter such as the MSD “Tach
Signal GMR Pickup” Part Number #8918 is usually
required when attempting to log engine rpm from
high-voltage noisy sources
Input Mode - Lap Beacon
·
Intended for use with a lap beacon receiver or similar
·
Inserts a generic, start/finish, or split marker into the
log file. See the AEMdata manual for further
information.
·
Configure whether marker is inserted on rising or
falling edge of lap beacon receiver output
·
After a lap beacon is detected on the input, lap
beacons will be ignored for the amount of time
configured by Beacon Obscuring Time
Calibration Data
·
View/create sensor calibrations
·
Scaling type is typically set to
Interpolate
.
Step
can
be used for gear position sensors as an example
·
View/set the units of the scaled value to be recorded
in the data log
·
View/set the calibration points/curve
·
The 2200 Ohm pull-up resistor is typically enabled for
two-wire RTD type sensors, unless that sensor is
already connected to another logger/ECU device
Configuration: Digital Inputs 1 - 3
Three digital inputs are available which are 12V tolerant and are considered 'ON' when a ground signal is applied to the
input pin.
Channel Options
·
Enabled checkbox determines if channel is logged or not
·
Set the name that will appear in the data log
·
Set the sampling rate of this input
Live Data
·
Displays the raw level measured at the input pin
·
Displays the scaled value as will be recorded in the log
·
AQ-1 requires 12V power at main connector for proper
readings
