P/N 30-2226
6 CHANNEL CAN SENSOR MODULE
AEM Performance Electronics, 2205 126th Street Unit A, Hawthorne, CA 90250 - Phone: (310) 484-2322
http://www.aemelectronics.com
STOP! - READ THIS BEFORE INSTALL OR USE!
WARNING:
THIS INSTALLATION MAY REQUIRE WELDING OR INTEGRATION INTO A VEHICLE'S ELECTRICAL SYSTEM. DAMAGE
TO SENSITIVE ELECTRONICS, FIRE, OR EXPLOSION MAY OCCUR IF PROPER PRECAUTION IS NOT TAKEN. IF THERE
IS ANY DOUBT,
DO NOT
ATTEMPT THE INSTALLATION AND CONSULT A PROFESSIONAL.
NOTE
: IT IS THE RESPONSIBILITY OF THE ENGINE TUNER TO ULTIMATELY CONFIRM THE CALIBRATION USE FOR
ANY PARTICULAR ENGINE IS SAFE FOR ITS INTENDED USE. AEM HOLDS NO RESPONSIBILITY FOR ANY ENGINE
DAMAGE THAT RESULTS FROM THE MISUSE OF THIS PRODUCT.
Instruction
Manual
The AEM 6 Channel CAN Sensor Module enables a user to put analog, fuel level, and tachometer signals onto an AEMnet
or CAN bus. The Sensor Module accommodates a wide variety of sensors and is housed in a sealed IP67 weather-
resistant enclosure. Sturdy construction, protected inputs, and simple configuration make this the perfect entry point to
get everything required to use an AEM CD-series dash on a carbureted or EFI vehicle. The Sensor Module supports the
Bosch CAN 2.0b standard making it compatible with many third-party devices. Note:
The only AEMnet devices that are
compatible with the CAN Sensor Module are the CD-series dash displays.
Features
·
Two (2) temperature (thermistor) inputs
·
Two (2) dedicated 0-5V analog inputs
·
One (1) dedicated fuel level input (0 to 250 Ohm
range)
·
One (1) tachometer/coil input
·
Fixed CAN bus speed, header length, and base
address
·
IP67 Potted Enclosure / Sealed Connector - "dust
tight" and protected against water spray
·
Protected inputs
PN
QTY
Description
35-2214
1
MODULE, 6 CHANNEL CAN SENSOR MODULE
10-2226
1
INST, MODULE, 22 CHANNEL CAN SENSOR
MODULE
1-3080
2
SCREW, FLT HD, 4-40X7/8"
1-2520
2
WASHER, 4-40 x .375"
35-5709
2
NUT, NYLOCK 4-40x9/64
4-1020
1
CONNECTOR, SLD, 12-WY PLG A
4-2013
13
TERMINAL, SKT, SZ 20, .05-.08
