4
e. Lift the coupler and hose assembly off the turbo inlet
to access the PCV hose. Disconnect it by pulling firmly
straight off. Remove the hose assembly from the vehicle.
3. Installation of AEM
®
intake system.
a. When installing the intake system, do not com-
pletely tighten the hose clamps or mounting
hardware until instructed to do so.
a. Install the turbo-end coupler and both corresponding
hose clamps onto the turbo.
b. Rotate the end of the PCV hose & push it straight in to
the port on the bottom of your new intake tube, then
install the tube into the turbo-end coupler. Do not tight-
en clamps yet.
c. Slide the other coupler & clamps onto the air box end
of the tube & lower the tube into position. Slide the cou-
pler into place over the air box.
d. Reinstall the tube mounting bolt taking care to posi-
tion your new intake tube with clearance all around.
