aem.eco
LAMBRECHT meteo
|
AEM
|
PRO-WEA
page
–
4
Mounting of the cup rotor and the wind vane at the sensor
The bores at the cup rotor and the wind vane are attached in such a way that they can only be installed in a certain clear
position. All 3 screws must be used to fasten the cup rotor resp. the wind vane. Thus the correct direction of rotation is
guaranteed. The necessary wrench is included in delivery.
Mounting options
Because the installation take place in a dangerous height, the assembly personal must follow the rules for
prevention of accidents.
I. TRAVERSE WITH SLOTTED BORES
(Id No.: 32.14567.010000)
The traverse has a slotted hole of Ø 30 mm at each of its two ends.
1. Remove the nut from the sensor.
2. Put a sensor with assembled cable sidewise into the bore.
3.
Attach the sensor with the flat side of detached nut from the lower side.
Tighten with a suitable tool (wrench size 40), until a twisting safety of the sensor aligned to the north is given.
II. MOUNTING IN BORES
The material thickness for mounting the sensor between the nuts must not exceed 10 mm.
1. Remove the thread nut from the sensor.
2. The sensor with cable-plug connection is led without cable into the bore and fastened by the opposite side with
the loose nut as under I.3.
1
Halbrundschraube mit
Innensechskant
round head screw with
hexagon socket
M3x8 DIN7380
2
Schalenstern / cup rotor
3
Schalensternglocke / cup rotor
protective globe
4
Skt-Stiftschlüssel / hex head
wrench
4
2
3
1
3
1
4
2
1
Schraube mit Innensechskant
screw with hexagon socket
M3x12 DIN7380
2
Windfahne / wind vane
3
Windfahnenglocke / wind vane protective globe
4
Skt-Stiftschlüssel / hex head wrench
