Water/Methanol Injection V2
7
© 2020 AEM Performance Electronics
Pump and Tank Install
Find a suitable location to mount the tank and
pump.
The tank must be mounted such that it is
below the injection point.
Failure to do so may
lead to fluid leaking into the intake tract due to
gravity or siphoning, which may result in
engine damage.
The tank and pump must be
mounted in the same area. Pump may be
mounted on exterior of vehicle but should be
mounted away from wheel wells or other areas
where it will come into direct contact with
water or road debris. Pump failures that have
clearly been caused by exposure to
water/mud/debris will not be covered under
warranty.
This includes, but is not limited to, the
bed of a truck and the inside of the fender wells.
Find a location where the pump will remain dry.
Use 4 of the 8 supplied #8 sheet metal screws along with the 4 large washers or the 5/16-18 bolts and Nylock
nuts to mount the 1.15-gallon tank.
(Optional 5-Gallon Tank Install)
Before mounting the tank, check the area under the desired mounting location for fuel tanks, fuel lines, or any
other obstructions. Mount the tank in an upright level position as shown below. Mark the four mounting points
and drill with a 3/8” bit. Use the supplied 5/16-18 bolts, nuts, and large OD flat washers for mounting the tank
into your vehicle.
IMPORTANT:
Use the supplied large OD washer to spread the load on the plastic mounting
ears of the tank.
DO NOT OVERTIGHTEN!
Nuts should just be snug; they are locking nuts and will not loosen.
Over-tightening will crack the plastic and cause leaks and void the warranty.
