The wireless interlinked alarms in one multi-pack have already been interconnected to each other, so
the alarms in each multi-pack have their own independent interlinked network. If you have more
than one multi-pack, you will need to connect them all to the same network, but you do not have to
disconnect each alarm individually. Choose one multi-pack as your base network and connect the
other multi-packs to it.
NOTE! The following instructions regarding wireless interconnection are applicable to X-SENSE
wireless interlinked alarms only.
How to Interconnect
1.
Make sure you only work with 2 units at a time, and that they are both activated to ensure successful
connection.
NOTE: To activate your alarms, remove the back cover from the device and pull out the battery
insulating film from the battery compartment. To learn how to turn on different models of
wireless interlinked alarms, please refer to their specific user manuals for more details.
2.
Press the pinhole pairing button on the back of one of the two units using the included pin. It will beep
once and the LED will flash red slowly, indicating it has entered pairing mode and is waiting for a new
unit to be added. Hold down the pinhole pairing button on the other unit until it beeps once and its
LED flashes red rapidly as it is searching for a unit to connect to.
3.
After the search is successful and an interconnected group is created, both units will beep once and
automatically exit the interconnection mode. At this point, both units will only flash once every 60
seconds, indicating they are in normal standby mode.
4.
If you want to connect a third alarm to this group, first activate the new device according to its
operating instructions. Press the pinhole pairing button on either of the two previously interconnected
units using the included pin, it will beep once and the LED will flash red slowly, indicating it has
entered pairing mode and is waiting for a new unit to be added. Hold down the pinhole pairing button
on the new unit until it beeps once and its LED flashes red rapidly as it searches for a network to
which it can connect. After the third unit successfully joins the interconnected network, both units will
beep once and automatically exit the interconnection mode.
5.
If you want to connect more units, simply repeat step 4.Up to 24 alarms can be interconnected this
way.
To ensure that all alarms enter the same interlinked network, make sure you only work
with 2 units at a time—one unit enters the pairing mode and the other unit enters the searching
mode.
6.
Test the alarms according to the steps in the section “Alarm Test”.