AEG SKK8182VDC, User Manual

Page: 12 / 20

Problem Possible cause Solution
The lamp is defective. Contact the nearest Author-
ised Service Centre.
The compressor operates
continually. Temperature is set incor-
rectly. Refer to "Operation".
Many food products were
put in at the same time. Wait some hours and then
check the temperature again.
The room temperature is
too high. Refer to climate class chart on
the rating plate.
Food products placed in
the appliance were too
warm. Allow food products to cool to
room temperature before stor-
ing.
The door is not closed cor-
rectly. Refer to "Closing the door".
The "COOLMATIC" is
switched on. Refer to "COOLMATIC func-
tion".
The compressor does not
start immediately after
pressing the "COOLMAT-
IC", or after changing the
temperature. This is normal, no error has
occurred. The compressor starts after a
period of time.
Water flows inside the refrig-
erator. Food products prevent the
water to flow into the wa-
ter collector. Make sure that food products
do not touch the rear plate.
The water outlet is clog-
ged. Clean the water outlet.
Water flows on the floor. The melting water outlet is
not connected to the
evaporative tray above the
compressor. Attach the melting water out-
let to the evaporative tray.
Temperature cannot be set. The "COOLMATIC func-
tion" is switched on. Switch off "COOLMATIC func-
tion" manually, or wait until
the function resets automati-
cally to set the temperature.
Refer to "COOLMATIC func-
tion".
dEMo appears on the dis-
play. The appliance is in demon-
stration mode. Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and dis-
play shuts off for a short time.
The temperature in the ap-
pliance is too low/too high. The temperature regulator
is not set correctly. Set a higher/lower tempera-
ture.
www.aeg.com 12