AEG SKE81821DS, User Manual

Page: 28 / 64

Problem Possible cause Solution
Food products placed in
the appliance were too
warm. Allow food products to cool to
room temperature before stor-
ing.
The door is not closed cor-
rectly. Refer to "Closing the door".
The "Coolmatic function"
is switched on. Refer to "Coolmatic function".
The compressor does not
start immediately after
pressing the "Coolmatic", or
after changing the tempera-
ture. This is normal, no error has
occurred. The compressor starts after a
period of time.
Water flows inside the refrig-
erator. Food products prevent the
water to flow into the wa-
ter collector. Make sure that food products
do not touch the rear plate.
The water outlet is clog-
ged. Clean the water outlet.
Water flows on the floor. The melting water outlet is
not connected to the
evaporative tray above the
compressor. Attach the melting water out-
let to the evaporative tray.
Temperature cannot be set. The "Coolmatic function"
is switched on. Switch off "Coolmatic func-
tion" manually, or wait until
the function resets automati-
cally to set the temperature.
Refer to "Coolmatic function".
dEMo appears on the dis-
play. The appliance is in demon-
stration mode. Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and dis-
play shuts off for a short time.
The temperature in the ap-
pliance is too low/too high. The temperature regulator
is not set correctly. Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly. Refer to "Closing the door".
The food products' tem-
perature is too high. Let the food products temper-
ature decrease to room tem-
perature before storage.
Many food products are
stored at the same time. Add less food products at the
same time.
The door has been
opened often. Open the door only if necessa-
ry.
www.aeg.com 28