AEG SCS6181VNS, User Manual

Page: 12 / 20

Problem Possible cause Solution
The compressor does not
start immediately after
pressing the "FROSTMAT-
IC", or after changing the
temperature. This is normal, no error has
occurred. The compressor starts after a
period of time.
Water flows on the rear
plate of the refrigerator. During the automatic de-
frosting process, frost
melts on the rear plate. This is correct.
Water flows inside the refrig-
erator. Food products prevent the
water to flow into the wa-
ter collector. Make sure that food products
do not touch the rear plate.
The water outlet is clog-
ged. Clean the water outlet.
Temperature cannot be set. The "FROSTMATIC " is
switched on. Switch off "FROSTMATIC "
manually, or wait until the re-
sets automatically to set the
temperature. Refer to
"FROSTMATIC ".
The temperature in the ap-
pliance is too low/too high. The temperature regulator
is not set correctly. Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly. Refer to "Closing the door".
The food products' tem-
perature is too high. Let the food products temper-
ature decrease to room tem-
perature before storage.
Many food products are
stored at the same time. Store less food products at the
same time.
The door has been
opened often. Open the door only if necessa-
ry.
The "FROSTMATIC " is
switched on. Refer to "FROSTMATIC ".
There is no cold air circula-
tion in the appliance. Make sure that there is cold air
circulation in the appliance.
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.
7.2
Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
7.3 Closing the door
1. Clean the door gaskets.
2.
If necessary, adjust the door. Refer to
assembly instructions.
www.aeg.com 12