AEG SCS51800S0, User Manual

Page: 28 / 40

Problem Possible cause Solution
Products prevent that wa-
ter flows into the water
collector. Make sure that products
do not touch the rear
plate.
Water flows on the
ground. The melting water outlet
does not flow in the evap-
orative tray above the
compressor. Attach the melting water
outlet to the evaporative
tray.
The temperature in
the appliance is too
low/high. The temperature regula-
tor is not set correctly. Set a higher/lower temper-
ature.
The temperature in
the refrigerator is
too high. There is no cold air circu-
lation in the appliance. Make sure that there is
cold air circulation in the
appliance.
The temperature in
the freezer is too
high. Products are too near to
each other. Store products so that
there is cold air circulation.
There is too much
frost. Food is not wrapped cor-
rectly. Wrap the food correctly.
The door is not closed
correctly. Refer to "Closing the
door".
The temperature regula-
tor is not set correctly. Set a higher temperature.
6.1 Replacing the lamp
1. Disconnect the mains plug from the
mains socket.
2. Remove the screw from the lamp
cover.
3. Remove the lamp cover (refer to the
illustration).
4. Replace the used lamp with a new
lamp of the same power and specifi-
cally designed for household appli-
ances. (the maximum power is
shown on the lamp cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the mains plug to the mains
socket.
8. Open the door. Make sure that the
lamp comes on.
6.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
28 www.aeg.com
Downloaded from Fridge-Manual.com Manuals