Problem
Possible cause
Solution
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.
This is normal, no error has
occurred.
The compressor starts after a
period of time.
Water flows on the rear
plate of the wine cooler .
During the automatic de-
frosting process, frost
melts on the rear plate.
This is correct.
Temperature cannot be set.
The FROSTMATIC or
COOLMATIC function is
switched on.
Switch off FROSTMATIC or
COOLMATIC manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FROSTMATIC
or COOLMATIC function".
dEMo appears on the dis-
play.
The appliance is in demon-
stration mode.
Keep the Mode button press-
ed for approximately 10 sec-
onds until a long sound is
heard and display shuts off for
a short time.
Door is misaligned or inter-
feres with ventilation grill.
The appliance is not level-
led.
Refer to "Levelling".
The temperature in the wine
cooler compartment too
low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The food products' tem-
perature is too high.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Many food products are
stored at the same time.
Store less food products at the
same time.
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.
8.2
Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
8.3
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to
assembly instructions.
3.
If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
ENGLISH
15
Summary of Contents for SCE72716VM
Page 1: ...USER MANUAL EN User Manual Wine Cooler Freezer SCE72716VM ...
Page 18: ...www aeg com 18 ...
Page 19: ...ENGLISH 19 ...