AEG SCB61826NS, User Manual

Page: 34 / 80

Problem Possible cause Solution
The lamp is defective. Contact the nearest Author-
ised Service Centre.
The compressor operates
continually. Temperature is set incor-
rectly. Refer to "Operation".
Many food products were
put in at the same time. Wait few hours and then check
the temperature again.
The room temperature is
too high. Refer to climate class chart on
the rating plate.
Food products placed in
the appliance were too
warm. Allow food products to cool to
room temperature before stor-
ing.
The door is not closed cor-
rectly. Refer to "Closing the door".
The "Frostmatic function"
or "Coolmatic function" is
switched on. Refer to "Frostmatic function"
or "Coolmatic function".
There is too much frost and
ice. The door is not closed cor-
rectly or the gasket is de-
formed/dirty. Refer to "Closing the door".
The water drainage plug is
not correctly positioned. Position the water drainage
plug in the correct way.
Appliance is fully loaded
and it is set to the lowest
temperature Set a higher temperature. Re-
fer to "Operation".
Temperature set in the ap-
pliance is too low and the
ambient temperature is
too high. Set a higher temperature. Re-
fer to "Operation"
Temperature is set incor-
rectly. Refer to "Operation" .
The compressor does not
start immediately after
pressing the "Frostmatic" or
"Coolmatic", or after chang-
ing the temperature. This is normal, no error has
occurred. The compressor starts after a
period of time.
Water flows on the rear
plate of the refrigerator. During the automatic de-
frosting process, frost
melts on the rear plate. This is correct.
www.aeg.com 34