AEG RMB952E6VU, User Manual

Page: 9 / 24

correspond with the coloured markings
identifying the terminals in your plug,
proceed as follows:
1. Connect the wire coloured green and
yellow to the terminal marked either
with the letter “E“ or by the earth
symbol or coloured green and
yellow.
2. Connect the wire coloured blue to the
terminal either marked with the letter
“N“ or coloured black.
3. Connect the wire coloured brown to
the terminal either marked with the
“L“ or coloured red.
4. Check that no cut, or stray strands of
wire is present and the cord clamp
(E) is secure over the outer sheath.
Make sure the electricity supply
voltage is the same as that indicated
on the appliance rating plate.
5. Switch on the appliance.
The appliance is supplied with a 13 amp
fuse (B). In the event of having to
change the fuse in the plug supplied, a
13 amp ASTA approved (BS 1362) fuse
must be used.
WARNING!
A cut off plug inserted into a
13 amp socket is a serious
safety (shock) hazard.
Ensure that it is disposed of
safely.
3.4 Levelling
When placing the appliance make sure
that it stands level. This can be achieved
by two adjustable feet at the bottom in
front.
3.5 Adjusting the door
If tops of the appliance upper doors are
not in line:
1. Make sure the appliance stands
level. Refer to the "Levelling" section.
2. Lift lower door slightly and insert a C
washer between bottom door and
middle hinge.
CAUTION!
Avoid fingers injury, use
a clip to insert the
washer.
Find spare C washers in
accessory bag.
CAUTION!
Keep C washers away
from children. Hazard of
swallowing.
3.6 Door reversibility
Reversing the door swing is not possible.
3.7 Rubber blocks
Every door contains one rubber block to
reduce closing impact.
If the rubber block is not in the place,
insert it as presented on the picture
below.
Find spare rubber blocks in
accessory bag.
ENGLISH 9