AEG RMB952E6VU, User Manual

Page: 20 / 24

Problem Possible cause Solution
There is too much frost and
ice.
The door is not closed cor‐
rectly.
Refer to the "Closing the
door" section.
The gasket is deformed or
dirty.
Refer to the "Closing the
door" section.
Food products are not wrap‐
ped properly.
Wrap the food products bet‐
ter.
Temperature is set incorrect‐
ly.
Refer to the "Operation"
chapter.
Appliance is fully loaded and
is set to the lowest tempera‐
ture.
Set a higher temperature.
Refer to the "Operation"
chapter.
Temperature set in the appli‐
ance is too low and the am‐
bient temperature is too
high.
Set a higher temperature.
Refer to the "Operation"
chapter.
Water flows on the rear plate
of the refrigerator.
During the automatic de‐
frosting process, frost melts
on the rear plate.
This is correct. Dry the water
with a soft cloth.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Door was open too frequent‐
ly.
Open the door only when
necessary.
Door was not closed com‐
pletely.
Make sure the door is closed
completely.
Stored food was not wrap‐
ped.
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Water flows on the floor. The melting water outlet is
not connected to the evapo‐
rative tray above the com‐
pressor.
Attach the melting water out‐
let to the evaporative tray.
Temperature cannot be set. The Super Freezing function
is switched on.
Switch off the Super Freez‐
ing function manually, or
wait until the function deacti‐
vates automatically to set
the temperature. Refer to the
"Super Freezing function"
section.
The temperature in the appli‐
ance is too low/too high.
The temperature is not set
correctly.
Set a higher/lower tempera‐
ture.
The door is not closed cor‐
rectly.
Refer to the "Closing the
door" section.
www.aeg.com 20