AEG RCB53426TX, User Manual

Page: 11 / 44

Problem Possible cause Solution
Audible or visual alarm is
on. The cabinet has been re-
cently switched on or the
temperature is still too
high. Refer to "Door Open Alarm/
Indicator" or "High Tempera-
ture Alarm/Indicator".
The temperature in the ap-
pliance is too high. Refer to "Door Open Alarm/
Indicator" or "High Tempera-
ture Alarm/Indicator".
The lamp does not work. The lamp is in stand-by
mode. Close and open the door.
The lamp is defective. Contact the nearest Author-
ised Service Centre.
The compressor operates
continually. Temperature is set incor-
rectly. Refer to "Operation"/"Control
Panel" chapter.
Many food products were
put in at the same time. Wait a few hours and then
check the temperature again.
The room temperature is
too high. Refer to climate class chart on
the rating plate.
Food products placed in
the appliance were too
warm. Allow food products to cool to
room temperature before stor-
ing.
The FROSTMATIC function
is switched on. Refer to "FROSTMATIC func-
tion".
The compressor does not
start immediately after
pressing the FROSTMATIC
or after changing the tem-
perature. This is normal, no error has
occurred. The compressor starts after
some time.
Water flows inside the re-
frigerator. The water outlet is clog-
ged. Clean the water outlet.
Food products prevent wa-
ter from flowing into the
water collector. Make sure that food products
do not touch the rear plate.
Water flows on the floor. The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor. Attach the melting water out-
let to the evaporative tray.
ENGLISH 11