Troubleshooting
31
The suds in the main
wash cycle create too
much foam.
Probably too much washing
powder was used.
Only use as much as the
washing powder manufac-
turer recommends.
Water is leaking out
from under the wash-
ing machine.
The clamp on the inlet hose
is not tight.
Tighten the inlet hose.
The inlet hose has a leak.
Check the inlet hose and if
necessary replace it.
The lid of the suds pump is
not correctly closed.
Close the lid correctly.
Washing is caught in the
door.
Abort the program, remove
the washing caught in the
door, start a new program.
Fabric softener is not
added, compartment
for fabric softener is
filled with water.
Suction cap in the compart-
ment for fabric softener is
not correctly fitted or is
blocked.
Clean the detergent com-
partment, fit the suction cap
on firmly.
Washing has not been
spun, there is water left
in the drum.
RINSE HOLD is selected.
Deselect RINSE HOLD.
The soaking program has
been completed.
Pump out the water and set
the main wash cycle
required.
Washing has not been
spun well, there is
water left in the drum.
There is a kink in the outlet
hose.
Eliminate the kink.
Maximum pumping height
(drain height 1m from the
position of the machine) is
exceeded.
Please contact the customer
service, it has a retro-kit
available for pump heights
above 1m.
Suds pump is blocked.
Switch off the machine and
pull the plug out of the
socket, clean the suds pump.
If a siphon is connected: the
siphon is blocked.
Clean the siphon.
The door cannot be
opened.
The program has not yet
been completed (display
lamp ON/OFF lights up).
Wait until the ON/OFF lamp
goes out.
Disturbance
Possible cause
Remedy
