AEG OKO FAVORIT 80800, Service Manual, Page: 12 / 20

Fault codes
Fault Fault
Code
LEDs Audible
Alarm
Display Description Symptom
Communication
Error
C0 Washing
— —
When no data can be
received between input
module and main PCB
after 10 attempts
Program is stopped
until communications
are restored
Water tap C1 End Once LED
water
Pressure switch level is
not reached within
60 sec.
Selected program LED
flashes. Program is
stopped. Can be
re-started by pressing
program button.
Acoustic signal is inter-
rupted by opening the
door.
Drain pump C2 Drying Twice — If reset point of pressure
Switch is not reached
within 120 sec, cycle will
stop Program LED flashes
program is stopped and
can continue by
pressing the program
button. Acoustic signal
is interrupted by the
door .
Aqua control
(float switch) C3 Drying
End
3 times — Drain pump is working
although it is not
selected by PCB
Program stops and
restarts automatically
once the fault is
rectified.
Acoustic signal is
interrupted by opening
the door.
—– C4 Final rinse —– —– —– —–
Turbidity sensor C5 Final rinse
end
5 times —– Turbidity signal can not
re-calibrate
Turbidity detected.
cycle run is adapted
accordingly.
—– C6 Final rinse
drying
—– —– —– —–
Heating C7 Final rinse
drying
End
7 times —– During heating temp has
not increased by 1.5 ºC
within 3 mins.
Cycle will continue to
the end without the
heating step.
NTC sensor C8 Rinsing 8 times —– NTC short circuit Cycle will continue to
the end without the
heating step.
Tacho C9 Rinsing
End
9 times —– With circulation pump
running no tacho signal
is received by PCB for
2 sec.
Circulation pump driven
without control.
No heating will take
place.
This function will be
controlled in every step.