Problem
Possible solution
The washing results are
not satisfactory.
• Increase the detergent quantity or use a different deter-
gent.
• Use special products to remove the stubborn stains before
you wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
Too much foam in the
drum during the washing
cycle.
• Reduce the quantity of detergent.
After the washing cycle,
there are some deter-
gent residues in the dis-
penser drawer.
• Make sure that the flap is in the correct position (left for
powder detergent - right for liquid detergent).
• Make sure you have used the detergent dispenser accord-
ing the indications given in this user manual.
The drum light does not
go on.
• Make sure that the LED lamp is not burned. To replace it,
contact the Authorised Service Centre.
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
14.
TECHNICAL DATA
Dimension
Width/ Height/ Depth/
Total depth
400 mm/ 890 mm/ 600 mm/ 600 mm
Electrical connection
Voltage
Overall power
Fuse
Frequency
220 - 240 V
2200 W
10 A
50 Hz
Level of protection against ingress of solid particles
and moisture ensured by the protective cover, ex-
cept where the low voltage equipment has no pro-
tection against moisture
IPX4
Water supply pressure
Minimum
Maximum
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Water supply
1)
Cold water
Maximum Load
Cotton
7 kg
Energy Efficiency Class
A+++ -20%
Spin Speed
Maximum
1300 rpm
1)
Connect the water inlet hose to a water tap with a 3/4'' thread.
ENGLISH
29