AEG LAVATHERM T35850, User Manual

Page: 14 / 28

What to do if ...
Troubleshooting by yourself
Problem Possible cause Remedy
Dryer does not work.
Mains plug is not plugged in or
fuse is not working correctly.
Plug in at mains socket. Check
fuse in fuse box (domestic in -
stallation).
Loading door is open. Close loading door.
Have you pressed the START
PAUSE button?
Press the START PAUSE button
again.
Drying results unsatisfactory.
Wrong programme selected.
Select a different programme
the next time you dry (see “Pro -
gramme chart” chapter).
Filter clogged. Clean filter.
Overloading of laundry.
Observe recommended loading
volumes.
Ventilation slots covered up. Uncover ventilation slots.
Residue on inside surface of
drum or drum ribs.
Clean inside surface of drum
and drum ribs.
Conductance of water at in -
stallation site differs from
standard setting of machine.
Re-programme standard set -
ting for degree of drying (see
‘Programming options’ chap -
ter).
Loading door does not close. Filter not in place. Install filter into place.
Drum light does not work.
Programme selector in OFF po -
sition.
Turn programme selector to
LIGHT or to any programme.
Defective light bulb.
Replace light bulb (see next
section).
Drying cycle ends shortly after
programme starts.
Not enough washing loaded or
washing loaded is too dry for
selected programme.
Select time programme or
higher drying level (e.g. EXTRA
DRY instead of STORAGE DRY).
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends au -
tomatically.
Filter clogged. Clean filter.
Load volume too big. Reduce load volume.
Laundry insufficiently spun.
Laundry must be adequately
spun.
Particularly high room temper -
ature. Temporary switching off
of the compressor to avoid
overload.
Automatic process, there is no
fault with the appliance. If pos -
sible, lower the room tempera -
ture.
14 What to do if ...