AEG LAVATHERM 61275AC, User Manual

Page: 15 / 68

• Always keep the airflow slots on the
bottom of the appliance clear.
• Make sure that is good airflow in the
appliance installation position.
10.2
Adjustment of the
remaining laundry moisture
degree
To change the default degree of the
remaining moisture of the laundry:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the Delicate and Anti-crease
buttons.
One of the symbols goes into the view
on the display:
- the maximum dry laundry
- the more dry laundry
- the standard dry laundry
5. Push the Start/Pause button again
and again until you set necessary
degree.
6. To memorise the setting, push at the
same time the Delicate and Anti-
crease buttons for approximately 2
seconds.
10.3 Deactivating the Tank
indicator
The water container indicator is by
default on. It starts to light at the end of
the drying cycle or during the cycle if the
water reservoir is full. If the draining kit is
installed the water container is drained
automatically and indicator can be
permanently off.
To deactivate the indicator:
1.
Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the
Delicate
and
Delay Start
buttons.
One of 2 configurations is possible:
• the Tank indicator: is on and the
symbol goes into the
view - the water container
indicator is permanently on
• the Tank indicator: is off and the
symbol goes into the
view - the water container
indicator is permanently off
11. CARE AND CLEANING
11.1 Cleaning the filter
At the end of each cycle the indicator
Filter is on and you must clean the filter.
The filter collects the fluff.
The fluff occurs while the
clothes are dried in the
tumble dryer.
To clean the filter:
1.
Open the door. Pull the filter.
2. Open the filter.
3. Use a moist hand to clean the filter.
ENGLISH 15