AEG LAVATHERM 59850, User Manual

Page: 100 / 104

6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section).
Changing the bulb for interior lighting
Only use a special bulb which is designed specially for dryers. The special bulb can be
obtained from your local service centre.
When the appliance is switched on, the interior lighting switches itself off after 4 mi
-
nutes when the door is open.
WARNING!
Do not use standard bulbs! These develop too much heat and may damage the appliance!
Before replacing the bulb, disconnect the mains plug; with a permanent connection:
fully unscrew or deactivate the fuse.
1. Unscrew cover above the bulb (this can be found directly behind the loading aper -
ture, at the top; refer to "Description of machine" section.)
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gasket before screwing back the door light cover.
Do not operate the dryer when missing o-ring gasket on door light cover.
WARNING!
For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer
must not be operated.
MACHINE SETTINGS
Setting Implementation
Buzzer permanent
on/off
1. Turn the programme selector to any programme.
2. Press simultaneously the DRYNESS (DROOGTEGRAAD) and SPIN
SPEED (T/MIN) buttons and hold down for approx. 5 seconds.
3. The buzzer is by default always off. You can use the buzzer option
to activate or deactivate sound but the machine does not memorise
your selection.
Water hardness
1) 1. Turn the programme selector to any programme.
2. Press simultaneously the DRYNESS (DROOGTEGRAAD) and TIME
(TIJD PROGR.) buttons and hold down for approx. 5 seconds. The cur -
rent setting is on the display:
–
low conductivity <300 μ S/cm
–
medium conductivity 300-600 μ S/cm
–
high conductivity >600 μ S/cm
3. Press the START PAUSE (START PAUZE) button sequentially until you
set desired level.
4. To memorise setting press simultaneously the DRYNESS (DROOGTE -
GRAAD) and TIME (TIJD PROGR.) buttons or turn knob to OFF (UIT)
position
100 Machine settings