5.
6.
7.
8.
12.8
Emergency drain
Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (8) of
'Cleaning the drain filter'. If necessary,
clean the pump.
When you drain the water with the
emergency drain procedure, you must
activate again the drain system:
1.
When you drain the water with the
emergency drain procedure, you
must activate again the drain system:
Put 2 litres of water in the main wash
compartment of the detergent
dispenser.
2.
Start the programme to drain the
water
12.9
Frost precautions
If the appliance is installed in an area
where the temperature can be less than
0° C, remove the remaining water from
the inlet hose and the drain pump.
1.
Disconnect the mains plug from the
mains socket.
2.
Close the water tap.
3.
Put the two ends of the inlet hose in
a container and let the water flow out
of the hose.
4.
Empty the drain pump. Refer to the
emergency drain procedure.
5.
When the drain pump is empty,
install the inlet hose again.
WARNING!
Make sure that the
temperature is more than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
13.
TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1
Introduction
The start of the appliance does not occur
or it stops during operation.
ENGLISH
41
Summary of Contents for LAVAMAT 6470FL
Page 1: ...NL Gebruiksaanwijzing 2 Wasautomaat EN User Manual 24 Washing Machine LAVAMAT 6470FL ...
Page 45: ...ENGLISH 45 ...
Page 46: ...www aeg com 46 ...
Page 47: ...ENGLISH 47 ...
