The water must be emptied out before
opening the door. During this time the
drum continues to turn at regular inter-
vals until water drain.
Follow the below instructions to empty
out the water:
• Turn the programme selector dial to
• Set the DRAIN or SPIN programme
• Reduce the spin speed, if needed
• Press the button
8
• When the programme has finished the
display shows a blinking . The pilot
light
C
goes off. The door can be
opened.
Turn the programme selector dial to
to switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the
door open to prevent the formation of
mildew and unpleasant smells.
Stand by
: once the programme has fin-
ished after a few minutes the energy sav-
ing system will be enabled. The bright-
ness of the display is reduced. By press-
ing any button the appliance will come
out of the energy saving status.
9.15
Drying only
The recommended load size is 3 kg for
cottons and linen, and 2 kg for synthetic
items.
It is also possible to dry up to 4
kg of cotton items (see the «Dry-
ing Programme » table).
The water tap must be open and the
drain hose must be positioned in the
sink or connected to the drain pipe.
1.
Load the laundry.
2.
Select a spin cycle at the maximum
spin speed allowed for the type of
laundry in order to obtain the best
drying performances.
3.
Set the drying programme for Cot-
tons or Synthetic in the Drying sec-
tor of the programme dial.
4.
Press button
6
to set the drying
time. Press this button again and
again until the time you want ap-
pears on the display.
For Cottons you can set a drying
time from 10 minutes to 250 minutes
(hours 4.10).
For Synthetic you can select a drying
time from 10 minutes to 130 minutes
(hours 2.10).
Every time you press this button the
drying time increases by 5 minutes.
Note! The programme time will au-
tomatically increase by a few mi-
nutes.
5.
Press button
8
to start the pro-
gramme.
After the programme has started,
the time remaining is updated every
minute.
If you set only 10 minutes of dry-
ing phase with the timed drying
button, the appliance performs
only a cooling phase.
6.
At the end of the drying pro-
gramme, some acoustic signals
sound. A blinking
appears on the
display.
The pilot light
B
, and
C
and the light
of the button
8
go off.
At this point, begins an anti-crease
phase, which lasts for about 10 mi-
nutes. During this time the light
C
is
on. The door cannot be opened.
If you need to open the door be-
fore or during the anti-crease
phase or to interrupt it, press any
button or turn the programme
dial to any programme position
(except
O
.
The door can be opened after
some minutes. (In any case do
not try to open the door if it is
locked!) .
7.
Turn the selector dial to the
O
posi-
tion to switch the machine off.
8.
Remove the laundry.
Note!
The different type of cottons (towelling,
sheets, shirts, and so on) or any laundry
items rolling up during the spinning
phase may result in partial dryness.
In the exceptional case that at the end of
the cycle the laundry remains slightly
wet, we suggest that you unfold the rol-
led up items, redistribute them evenly in
18 www.aeg.com
Summary of Contents for LAVAMAT 61271 WDBI
Page 1: ...LAVAMAT 61271 WDBI 1 8VHU PDQXDO ...
Page 38: ...38 www aeg com ...
Page 39: ... 1 6 39 ...
