3.
Set the hose correctly by loosening the
ring nut. After positioning the inlet
hose, be sure to tighten the ring nut
again to prevent leaks.
4.
Connect the appropriate end of the hose
to a tap with a 3/4” thread. Always use
the hose supplied with the appliance.
WARNING!
Installation should comply with local water authority and building regulations’ require
-
ments.
The appliance must be connected to a cold water supply.
A minimum water pressure of 0.05 MPa (0.5 bar) is required for safe operation of the appli
-
ance.
If you cannot make the cold water connection direct from the rising mains, you may be
able to operate the appliance from your cold water storage system.
There should be a minimum vertical distance of 5.02 m (16.5 ft) between the appliance’s
inlet and the bottom of the water storage tank.
Water drainage
This appliance is designed to be permanently plumbed into your home's drainage system
using one of the following methods.
1.
Into a drainage standpipe
Firstly form a hook in the end of the
drain hose using the “U” piece” supplied.
Place the drain hose into your stand
-
pipe, which should have an internal di
-
ameter of approximately 38 mm thus
ensuring there is an air break between
the drain hose and standpipe.
38 mm (11.2”)
standpipe
diameter
30 cm(12”)
Installation
41
Summary of Contents for LAVAMAT 14840
Page 1: ...LAVAMAT 14840 EN User manual ...
Page 45: ...45 ...
Page 46: ...46 ...
Page 47: ...47 ...
