13.
TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1
Introduction
The appliance does not start or it stops
during operation.
First try to find a solution to the problem
(refer to the table). If the problem
persists, contact the Authorised Service
Centre.
In case of major problems, the acoustic
signals operate, the display shows an
alarm code and the
Início/Pausa
button
may flash continuously:
•
- The appliance does not fill with
water properly.
•
- The appliance does not drain
the water.
•
- The appliance door is open or
not closed correctly. Please check the
door!
If the appliance is
overloaded, remove
some items from the
drum and/or keep
pressed the door while
touching the Início/Pausa
button until the indicator
stops flashing (see
the picture below).
•
- The mains supply is unstable.
Wait until the mains supply is stable.
•
- No communication between
electronic elements of the appliance.
Switch it off and switch on again.
•
- The anti-flood device is on.
Disconnect the appliance and close
the water tap. Contact the Authorised
Service Centre.
WARNING!
Deactivate the appliance
before carrying out any
check.
13.2
Possible failures
Problem
Possible solution
The programme does
not start.
Make sure that the mains plug is connected to the mains sock-
et.
Make sure that the appliance door is closed.
Make sure that there is not a damaged fuse in the fuse box.
Make sure that the Início/Pausa has been touched.
If the delay start is set, cancel the setting or wait for the end of
countdown.
Deactivate the Child Lock function, if it is on.
www.aeg.com
32
