Changing the delay start after
the countdown has started
To change the delay start:
1.
Touch the Start/Pause button to
pause the appliance. The related
indicator flashes.
2.
Touch the Zeitvorwahl button
repeatedly until the display shows
the desired delay time.
3.
Touch the Start/Pause button again
to start the new countdown.
10.7
Starting a programme
Touch the Start/Pause button to start the
programme.
The related indicator stops flashing and
stays on.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
10.8
The ProSense load
detection
The programme duration in
the display is referred to a
medium/high load
.
After touching the Start/Pause button,
the maximum declared load indicator
goes off, the indicator
flashes, the
ProSense starts the laundry load
detection:
1.
The appliance detects the load in the
first 30 seconds: the indicator and
the time dots flash, the drum
rotates shortly.
2.
At the end of the load detection, the
indicator goes off and the time
dots stop flashing. The programme
duration will be adjusted accordingly
and could increase or decrease. After
further 30 seconds, the water filling
starts.
At the end of the load detection,
in case
of drum overload
, the indicator
is
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pause button to start the
programme again. The ProSense phase
can be repeated up to three times (see
point 1).
Important!
If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again
depending on the capacity
of water absorption of the
fabrics.
The ProSense detection is
carried out with complete
washing programmes only
(no skipping phase
selected).
10.9
Programme phase
indicators
When the programme starts the indicator
of the running phase flashes and the
other phase indicators are steady on.
E.g. the washing or pre wash phase is
running:
.
When the phase ends the relevant
indicator stops flashing and is steady on.
The next phase indicator starts flashing.
E.g. the rinse phase is running:
.
10.10
Interrupting a
programme and changing the
options
When the programme is running, you
can change
only some
options:
1.
Touch the button Start/Pause
.
The related indicator flashes.
www.aeg.com
22
