45°
20°
6.
Install again the inlet hose. Make sure
that the couplings are tight to pre-
vent leakages.
7.
Open the water tap.
EMERGENCY DRAIN
Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (6) of
'To clean the drain pump'.
If necessary, clean the pump.
Put the drainage duct back and close the
drain pump flap.
When you drain the water with the emer-
gency drain procedure, you must activate
again the drain system:
1.
Put 2 litres of water in the main wash
compartment of the detergent dis-
penser.
2.
Start the programme to drain the wa-
ter.
FROST PRECAUTIONS
If the appliance is installed in an area
where the temperature can be less than 0
°C, remove the remaining water from the
inlet hose and the drain pump.
1.
Disconnect the mains plug from the
mains socket.
2.
Close the water tap.
3.
Remove the water inlet hose
4.
Put the two ends of the inlet hose in a
container and let the water flow out
of the hose.
5.
Empty the drain pump. Refer to the
emergency drain procedure
6.
When the drain pump is empty, install
the inlet hose again.
WARNING!
Make sure that the temperature is
more than 0 °C before you use the
appliance again.
The manufacturer is not responsi-
ble for damages caused by low
temperatures.
24 www.aeg.com
Summary of Contents for L 70270 VFL
Page 1: ...L 70270 VFL L 70470 FL EN WASHING MACHINE USER MANUAL ...
Page 34: ...34 www aeg com ...
Page 35: ...ENGLISH 35 ...
