AEG FAVORIT 88089, User Manual, Page: 23 / 40

WHAT TO DO IF…
The appliance does not start or stops during operation.
If there is a fault, first try to find a solution to the problem yourself. Refer to following
charts. If you cannot find a solution to the problem, contact your dealer or the Customer
Care Centre.
With some malfunctions, the display shows an alarm code:
• - The appliance does not fill with water
• - The appliance does not drain the water
• - The anti - flood device operates.
WARNING!
Switch the appliance off before you do the suggested corrective actions.
Malfunction Possible cause Possible solution
The appliance does
not fill with water
The water tap is closed. Open the water tap.
The filter in the water inlet hose is
blocked.
Clean the filter.
The installation of the water inlet
hose is not correct. The hose is bent
or squashed.
Make sure that the installation is
correct.
The water tap is blocked or restricted
with limescale.
Clean the water tap.
The water pressure is too low. Contact your local water authority.
The appliance does
not drain the water
There is a blockage in the sink spi-
got.
Clean the sink spigot.
The installation of the water drain
hose is not correct. The hose is bent
or squashed.
Make sure that the installation is
correct.
The anti - flood device
operates
Close the water tap and contact
your Customer Care Centre.
The program does
not start
The appliance door is not closed. Close the door.
Mains plug is not connected. Plug - in the appliance to the mains.
The delay start is set. • Cancel the delay start.
• Wait until the countdown of the
delay start is completed.
The fuse has blown out in the
household fuse box
Replace the fuse.
After the check, switch on the appliance. The program continues from the point of inter-
ruption. If the malfunction occurs again, contact your Customer Care Centre.
What to do if… 23