16
Setting the amount of rinse aid required
3
Only change the amount dispensed, if smears, milky spots (reduce the
amount) or dried on water spots (increase the amount) can be seen on
glasses and dishes. (See section “If dishwashing results are not satisfac-
tory”.) The dosage can be set from 1-6. The dosage is pre-set to “4” in
the factory.
1.
Open the dishwasher door.
2.
Press the release button on the rinse
aid compartment.
3.
Open the cover.
4.
Set the dosage level.
5.
Press the lid shut until it clicks into
place.
6.
If rinse aid has leaked out, wipe it
away with a cloth.
Setting the acoustic signal
In addition to the optical display (e.g. indicating the end of the cycle,
errors) you can also choose to set an acoustic signal.
1.
Press the ON/OFF button.
3
If the name of a stage of a cycle is shown on the display, this means a
rinsing cycle is active. You must first of all cancel the rinsing cycle:
–
Press the RESET key combination.
The display will read CONFIRM CANCEL?
–
Press the OK/START button. This will cancel the rinsing cycle.
2.
Go to the SOUND VOLUME setting; see the section “Adapting an op-
tion/setting”.
3.
Set the value for the sound volume.
You can set a value from 0 to 5. At 5 the acoustic signals are very loud,
at 0 no acoustic signals are emitted; in addition the symbol
is lit in
the display.