1)
Factory position.
2)
Do not use salt at this level.
You must adjust the water soft-
ener manually and electronically.
Manual adjustment
Turn the water hardness dial to the posi-
tion 1 or 2.
Electronic adjustment
1.
Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode. Refer to
‘SETTING AND STARTING A PRO-
GRAMME’.
2.
Turn the programme knob until the
display shows two horizontal status
bars.
3.
Press and hold
Multitab
and
Delay
at the same time until the indicators
,
, and
flash.
4.
Press
Multitab
.
• The indicators
and
go off.
• The indicator continues to flash.
• The display shows the setting of
the water softener, e.g.
= level
5.
5.
Press
Multitab
again and again to
change the setting.
6.
Deactivate the appliance to confirm
the setting.
6.2
Filling the salt container
1.
Turn the cap counterclockwise and
open the salt container.
2.
Put 1 litre of water in the salt con-
tainer (only for the first time).
3.
Fill the salt container with dishwash-
er salt.
4.
Remove the salt around the opening
of the salt container.
5.
Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out
from the salt container when you
fill it. Risk of corrosion. To pre-
vent it, after you fill the salt con-
tainer, start a programme.
ENGLISH
25