Option
Description
1
1:00 h for a
low degree of
dirt
2
1:30 h for a
usual degree
of dirt
3
2:30 h for a
high degree
of dirt
You can use the End function to
delay the start of the cleaning
procedure.
7.
Touch
to activate the Pyrolysis
function.
12.4
Cleaning reminder
To remind you that the pyrolytic cleaning
is necessary, the cleaning reminder
symbol
flashes in the display after
each deactivation of the appliance for
the next 10 seconds.
The cleaning reminder
goes out:
• after the end of the
pyrolytic cleaning.
• when you deactivate it in
the basic settings. Refer
to "Using the settings
menu".
12.5
Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1.
Open the door fully.
2.
Fully press the clamping levers (A) on
the two door hinges.
A
A
3.
Close the oven door to the first
opening position (approximately 70°
angle).
4.
Hold the door with one hand on each
side and pull it away from the
appliance at an upwards angle.
5.
Put the door with the outer side
down on a soft cloth on a stable
surface. This is to prevent scratches.
6.
Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
1
2
B
7.
Pull the door trim to the front to
remove it.
8.
Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9.
Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger and the door.
www.aeg.com
36
