AEG B3007H-B, User Manual

Page: 11 / 38

11
Attention: after a power failure any automatic or semi-automatic programme is
cancelled. Turn off the oven manually.
During an automatic or semi-automatic cooking programme it is possible to change
the cooking function and the temperature at any time.
3.4 Automatic cooking modes - Based on setting a cook stop time
Turn the oven on as indicated in paragraph 2.3. Press the button
“ ” three times, the
display shows “End”. Set the end time using buttons “ ” or “ ”, so the time falls in
the following 23h59m.
Input the time following the same procedures as the clock setting: you set the hours and then
the minutes. After 4 sec from the last push of a button, the oven will operate until the
specified cooking duration time.
Select a cooking function, the oven suggests a default temperature, the temperature can be
changed by using the buttons
“ ” or “ ”,.
After the elapsed time, the ov
en enters in “Cooking end” mode.
3.5 Fully automatic
– (Start Later – Stop Later)
Turn the oven on as indicated in paragraph 2.3. Select a cooking function, the oven is set at
the typical default temperature for the function selected. The temperature can be changed by
using the buttons
“ ” or “ ”.
This function is a combination of the two settings of
‘duration’ and ‘end’, set separately, in
either order (first the duration and then the end or vice versa).
Within 4 sec from the last selection, the oven will be in delayed start mode: it will later operate
automatically for the specified cooking duration and will stop at the set end cooking time.
After the elapsed time, the oven enters in “Cooking end” mode.
During the delayed start both the temperature and oven function are shown, and both are
adjustable.
The temperature bar remains off before cooking starts to show that cooking is not currently
running. All settings are turned off until the cooking commences.
3.6 End cooking mode
At the end of cooking time, the oven turns off all settings, it activates a triple beep
intermittently;
The temperature and program displays are switched off. The timer display shows the time of
day and the two symbols
‘Pot’ and ‘Auto’ flash.
To unlock the oven, just press any button below the timer display: the acoustic signal ends,
the oven is ready to receive new commands, you can select a new cooking function, or turn it
off with the button .
3.7 Cancelling a set program
To cancel a set programme (“
A
” symbol activated on the programmer display):
– Select “
dur
” on the programmer display by touching the key “ ” and then touch
“ ” key.
– A set programme is also cancelled when the oven is switched OFF in the “stand-by” mode.
At the next power up the oven is not programmed.
IMPORTANT: If the oven is ON, remember to switch it off manually otherwise it does not
stop operating in the set mode.