Problem
Possible cause
Solution
Food products placed in the
appliance were too warm.
Allow food products to cool
to room temperature before
storing.
The door is not closed cor‐
rectly.
Refer to "Closing the door"
section.
The FROSTMATIC function
is switched on.
Refer to "FROSTMATIC
function" section.
The compressor does not
start immediately after
pressing the "FROSTMAT‐
IC", or after changing the
temperature.
The compressor starts after
a period of time.
This is normal, no error has
occurred.
Door is misaligned or inter‐
feres with ventilation grill.
The appliance is not level‐
led.
Refer to installation instruc‐
tions.
Door does not open easily.
You attempted to re-open
the door immediately after
closing.
Wait a few seconds between
closing and re-opening of
the door.
Side panels of the appliance
are warm.
This is a normal state
caused by operation of the
heat exchanger.
The lamp does not work.
The lamp is in stand-by
mode.
Close and open the door.
The lamp is defective.
Contact the nearest Author‐
ized Service Centre.
There is too much frost and
ice.
The door is not closed cor‐
rectly.
Refer to "Closing the door"
section.
The gasket is deformed or
dirty.
Refer to "Closing the door"
section.
Food products are not wrap‐
ped properly.
Wrap the food products bet‐
ter.
Temperature is set incorrect‐
ly.
Refer to "Control Panel"
chapter.
Appliance is fully loaded and
is set to the lowest tempera‐
ture.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Temperature set in the appli‐
ance is too low and the am‐
bient temperature is too
high.
Set a higher temperature.
Refer to "Control Panel"
chapter.
ENGLISH
15
