AEG ABE812E6NC, User Manual

Page: 15 / 40

Problem Possible cause Solution
Food products placed in the
appliance were too warm. Allow food products to cool
to room temperature before
storing.
The door is not closed cor-
rectly. Refer to "Closing the door"
section.
The Frostmatic function is
switched on. Refer to "Frostmatic func-
tion" section.
The compressor does not
start immediately after
pressing the "Frostmatic", or
after changing the tempera-
ture. The compressor starts after a
period of time. This is normal, no error has
occurred.
Door is misaligned or inter-
feres with ventilation grill. The appliance is not level-
led. Refer to installation instruc-
tions.
Door does not open easily. You attempted to re-open
the door immediately after
closing. Wait a few seconds between
closing and re-opening of
the door.
There is too much frost and
ice. The door is not closed cor-
rectly. Refer to "Closing the door"
section.
The gasket is deformed or
dirty. Refer to "Closing the door"
section.
Food products are not wrap-
ped properly. Wrap the food products bet-
ter.
Temperature is set incorrect-
ly. Refer to "Control Panel"
chapter.
Appliance is fully loaded and
is set to the lowest tempera-
ture. Set a higher temperature.
Refer to "Control Panel"
chapter.
Temperature set in the appli-
ance is too low and the am-
bient temperature is too
high. Set a higher temperature.
Refer to "Control Panel"
chapter.
Water flows on the floor. The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor. Attach the melting water
outlet to the evaporative
tray.
ENGLISH 15