AEG ABB68811LS, User Manual

Page: 26 / 60

Problem Possible cause Solution
The door is not closed cor-
rectly. Refer to "Closing the door".
The FROSTMATIC function
is switched on. Refer to "FROSTMATIC
function".
There is too much frost and
ice. The door is not closed cor-
rectly or the gasket is de-
formed/dirty. Refer to "Closing the door".
The water drainage plug is
not correctly positioned. Position the water drainage
plug in the correct way.
Food products are not wrap-
ped properly. Wrap the food products bet-
ter.
Temperature is set incorrect-
ly. Refer to "Operation" chap-
ter.
The compressor does not
start immediately after
pressing the "FROSTMAT-
IC", or after changing the
temperature. This is normal, no error has
occurred. The compressor starts after a
period of time.
Temperature cannot be set. The "FROSTMATIC func-
tion" is switched on. Switch off "FROSTMATIC
function" manually, or wait
until the function resets au-
tomatically to set the tem-
perature. Refer to "FROST-
MATIC function".
The temperature in the ap-
pliance is too low/too high. The temperature regulator is
not set correctly. Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly. Refer to "Closing the door".
The food products' tempera-
ture is too high. Let the food products tem-
perature decrease to room
temperature before storage.
Many food products are
stored at the same time. Store less food products at
the same time.
The thickness of the frost is
greater than 4-5 mm. Defrost the appliance.
The door has been opened
often. Open the door only if neces-
sary.
The FROSTMATIC function
is switched on. Refer to "FROSTMATIC
function".
www.aeg.com 26