tance between the wall and the cabinet must be at least 10 mm to allow the door to open
enough so that the shelves can be removed.
WARNING!
It must be possible to disconnect the appliance from the mains power supply; the plug
must therefore be easily accessible after installation.
Door reversibility
To carry out the following operations, we suggest that this be made with another person
that will keep a firm hold on the doors of the appliance during the operations.
To change the opening direction of the door, do these steps:
1.
Remove the plug from the power socket.
2.
Tilt back the appliance carefully so that the compressor cannot touch the floor.
3.
Unscrew both adjustable feet.
4.
Unscrew the screws of the door bottom
hinge.
5.
Take off the appliance door by pulling it
slightly downwards.
6.
Unscrew the top door hinge pin of the
appliance then screw it back on the oth-
er side.
7.
Fit the appliance door on the upper door
hinge pin.
8.
Remove the lower hinge. Put over the
pin in the direction of the arrow.
9.
Unscrew and install the screw on the
opposite side.
10. Install the lower hinge on the opposite
side leaving the position of the door un-
changed.
11. Screw in the one screw in the place set free on the other side as well as the adjustable
feet (2 pieces).
16
Installation
