• Refit the upper hinge pin into the op-
posite location.
• Fit the door in place on the hinge pin.
• Slot the hinge pin into the hole in the
hinge plate and relocate the hinge as-
sembly to the opposite location and
refit using the retaining screws.
• Refit the bottom hinge plate assembly
on the opposite side, taking care that
the edge of the door is parallel with
the side of the cabinet.
1
2
• Remove and install the handle (if fore-
seen)on the opposite side.
• Reposition, level the appliance, wait
for at least four hours and then con-
nect it to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly
to the cabinet. In that case, wait for the
natural fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact
the nearest After Sales Service Force.
The After Sales Service specialist will car-
ry out the reversibility of the doors at
your cost.
9.5
Electrical connection
Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic pow-
er supply.
The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the do-
mestic power supply socket is not earth-
ed, connect the appliance to a separate
earth in compliance with current regula-
tions, consulting a qualified electrician.
The manufacturer declines all responsi-
bility if the above safety precautions are
not observed.
This appliance complies with the E.E.C.
Directives.
30 www.aeg.com
Summary of Contents for A51100TSW0
Page 66: ...66 www aeg com ...
Page 67: ...DEUTSCH 67 ...
