1. Clean and regenerate the filter first,
then place it back inside the hood.
2. Press briefly, while the indicator is
blinking.
The counter restarts.
WARNING!
An oversaturated filter can
pose a risk of fire.
10. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
10.1 What to do if...
Problem
Possible cause
Remedy
You cannot activate or op‐
erate the hob.
The hob is not connected to
an electrical supply or it is
connected incorrectly.
Check if the hob is correctly
connected to the electrical
supply.
The fuse is blown.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
You do not set the heat set‐
ting for 60 seconds.
Activate the hob again and set
the heat setting in less than 60
seconds.
You touched 2 or more sen‐
sor fields at the same time.
Touch only one sensor field.
Pause operates.
Refer to "Daily use".
There is water or fat stains
on the control panel.
Clean the control panel.
You can hear a constant
beep noise.
The electrical connection is
incorrect.
Disconnect the hob from the
electrical supply. Ask a quali‐
fied electrician to check the in‐
stallation.
You cannot select the
maximum heat setting for
one of the cooking zones.
The other zones consume
the maximum available pow‐
er.
Your hob works properly.
Reduce the heat setting of the
other cooking zones connec‐
ted to the same phase. Refer
to "Power management".
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactiva‐
ted.
You put something on one or
more sensor fields.
Remove the object from the
sensor fields.
The hob deactivates.
You put something on the
sensor field .
Remove the object from the
sensor field.
ENGLISH
25
