AEG 37699MO-MN, User Manual

Page: 5 / 28

ENGLISH 5
• In the case of a failure or malfunction,
turn the appliance off and switch
off the electrical supply and do
not tamper with it. All repairs or
adjustments must be carried out
with maximum care and the proper
attention of an authorised person.
• For this reason we recommend you
call our Service Centre.
For your safety
If you smell gas:
1. Turn off gas supply at bottle
2. Extinguish all naked flames
3. Do not operate any electrical
appliances
4. Ventilate the area
5. Check for leaks as detailed in this
manual
If odour persists, contact your dealer
or gas supplier immediately
Burn-back (fire in burner tube
or chamber)
In the event of a burn-back, where
the flame burns back to the jet,
immediately turn the gas supply
off at the control valve on the
panel. After ensuring the flame is
extinguished, wait for I minute and
re-light the appliance in the normal
manner. Should the appliance again
burn back, close the control valve
and call a service technician. Do not
use the appliance again until the
service technician has declared that it
is safe to do so.
Gas-pressure regulator
This appliance requires an operating
pressure of 2,8 kPa at the appliance.
A suitable LPG regulator that
complies with the requirements of
SANS 1237 must be installed.
Important information for the
user
This appliance may only be installed by
a registered SAQCC Gas installer.
All registered installers are issued
with a card carrying their registration
number. Ask to be shown the card
before allowing the installation work
to commence and make a note of the
Installer registration number. Upon
completion of the installation, the
installer is required to explain the
operational details of the appliance
together with the safety instructions.
You will be asked to sign acceptance
of the installation and be provided
with a completion certificate. You
should only sign for acceptance of
the installation when the installation
is completed to your satisfaction.
Note that your invoice is required in
the event that you wish make a
guarantee claim.
Important information for the
installer.
This appliance may only be installed
by a gas installer registered with
the South African qualification and
certification committee (SAQCC).
The appliance must be installed in
accordance with the requirements
of SANS 10087-1for use with LPG,
SANS 827 for use with NG and any
fire department regulations and/or
local bylaws applicable to the area.
If in doubt, check with the relevant
authority before undertaking the
installation. Upon completion of the
installation you are required to fully
explain and demonstrate to the user
the operational details and safety
practices applicable to the appliance
and the installation.