32
Installation
Electrical Connection
This hob is provided with a connection cable type H05 V
2
V
2
-F
T90, section 3 x 1,5 mm
2
. A suitable plug must be fitted to the
cable and then connected to a suitable plug, according with
spexcification given on the rating plate.
If connectiong the hob directly to the power mains, a double pole
switch should be fitted, with a minimum gap of 3 mm. between
the switch contacts and of a type suitable for the required load in
compliance with the current electric regulations.
The switch must not break the yellow and green earth cable at
any point.
Ensure that the hob supply cord does not come into contact
with surfaces whose temperature exceed 90°C over room
temperature..
Replacement of connection cable
The connection of the voltage cable to the appliance's terminal
block is of type "Y". This means that its replacement requires
the specific equipment of a technician.
In this case, only cable type H05V2V2-F T90 must be used. The
cable section must be suitable to the voltage and the working
temperature.
The yellow/green earth wire must
be approximately 2 cm. longer than
the phase wires .
To open the terminal block and
reach the terminals, proceed as
follows:
1) insert the point of a screwdriver into
the visible protrunding part of the
terminal block;
2) exert a light pressure and lift.
