When the cleaning is completed, install
the glass panels and the oven door. To
install the oven door, do the above steps
in the opposite sequence.
4
4
5
5
6
12.6
Replacing the lamp
Put a cloth on the bottom of the interior
of the appliance. It prevents damage to
the lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.
1.
Deactivate the appliance.
2.
Remove the fuses from the fuse box
or deactivate the circuit breaker.
The back lamp
1.
Turn the lamp glass cover
counterclockwise to remove it.
2.
Clean the glass cover.
3.
Replace the lamp with a suitable 300
°C heat-resistant lamp.
4.
Install the glass cover.
13.
TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1
What to do if...
Problem
Possible cause
Remedy
You cannot activate the ap-
pliance.
The appliance is not connec-
ted to an electrical supply or
it is connected incorrectly.
Check if the appliance is cor-
rectly connected to the elec-
trical supply.
You cannot activate or oper-
ate the hob.
The oven does not heat up.
The fuse is blown.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
The oven / hob display
shows an error code that is
not in this table.
There is an electrical fault.
Deactivate the appliance
with the house fuse or the
safety switch in the fuse box
and activate it again.
If the display shows the error
code again, contact the Cus-
tomer Care Department.
www.aeg.com
24
Summary of Contents for 10369MN-MN
Page 1: ...EN User Manual Cooker 10369MN MN ...
Page 34: ...www aeg com 34 ...
Page 35: ...ENGLISH 35 ...