Ice & Water
Filter
continued
TO CHANGE REAR FILTER:
(some
models)
Refer to Figure 3 as needed. It is not
necessary to turn the water supply off to
change filter.
1. Set ice maker lever (wire signal arm) to
the OFF (up) position.
2. Hold filter cup firmly, and unscrew
counterclockwise (Figure 3).
NOTE:
Some water could leak out as
you remove cup. This is normal. Filter
cartridge should come down with cup. If
cartridge remains in housing, pull down
gently, while twisting filter back and
forth.
3. Empty cup of any substance.
4. The large o-ring (Figure 3) that seals the
filter system sets in the o-ring groove
down inside the cup. Should the o-ring
fall out during filter cartridge replace-
ment, simply place it back in the groove
prior to screwing the cup back in place.
5. Remove new filter cartridge from pack-
aging, and install.
(continued)
Threads
Rosca
Filetage
Gewinde
Óðåéñþìáôá
̾Zx£À~
Filter Cartridge
Cartucho de filtro
Cartouche de filtre
Filterpatrone
Öýóéããá Ößëôñïõ
|£¹³ûZ æ®
Filter Cup
Copa del filtro
Porte-filtre
Filtertopf
Êýðåëëï ôïõ Ößëôñïõ
|£¹³ûZ iÆ
Large O-Ring
Anillo tórico grande
Grande bague d’étanchéité
Großer O-Ring
ÌåãÜëïò Äáêôýëéïò O
y®Ã¤¼Z 殡Z¬Z 溾©Z
Small O-Ring
Anillo tórico pequeño
Petite bague d’étanchéité
Kleiner O-Ring
Ìéêñüò Äáêôýëéïò O
y®Ã¸³Z 殡Z¬Z 溾©Z
Filter Housing
Logement du filtre
Cubierta del filtro
Filtergehäuse
ÈÞêç Ößëôñïõ
|£¹³ûZ Ìî x£¼
Figure 3
Figura 3
Figure 3
Abbildung 3
Ó÷Þìá 3
3 á¼
ZUM ENTFERNEN ABSCHRAUBEN
TWIST TO REMOVE
GIRE PARA SACAR
TOURNEZ POUR ENLEVER
ÐÅÑÉÓÔÑÅØÔÅ
ÃÉÁ ÍÁ ÁÖÁÉÑÅÓÅÔÅ
ä¯À å yfd~
Ice & Water
Filter
continued
6. Place filter cartridge in cup. The end with
the small o-ring should be up, out of
the cup.
7. Screw cup, with filter, back into housing.
Filter cartridge will self-align as cup is
tightened. Ensure that cup is completely
tightened, with the words “Twist To
Remove” facing outward. DO NOT
TIGHTEN PAST STOP.
8. Set ice maker lever to the ON (down)
position.
9. Check for leaks. Open refrigerator door.
Wipe any water drops from filter cup.
Run a glass of water. If there is a leak,
unscrew filter cup, and reinsert filter
cartridge. Check placement of large O-
ring (see directions following). Reinstall
filter cup.
10.To condition filter system and purge air
from water line, run several glasses of
water through water dispenser. This will
also assure that the purest water pos-
sible is stored in water tank.
Resetting The Filter Indicator (some models)
After replacing the filter carttridge, it will be
necessary to press the
Filter Reset
touchpad
located on the ice and water dispenser. This
will reset the Change Filter Indicator. Push
the reset button until the green light
flashes (3-15 seconds).
8
