background image

Ice & Water
Dispenser

AUTOMATIC ICE & WATER
DISPENSER (some models)

The ice and water dispenser on the freezer
door conveniently dispenses chilled water
and ice. To operate the dispenser, select the
ice option desired using the touch pad, and
press a glass against the dispensing arm. To
stop dispensing, pull glass away from
dispensing arm. When dispensing ice,
release dispensing arm before the glass is
full. Allow ice chute to clear or water to stop
before removing glass.

A

 

drip tray located beneath the dispenser

catches and evaporates small spills. This
drip tray is removable and dishwasher safe.
It is NOT a drain, DO NOT pour water
directly into this area.
LOCK OUT FEATURE (some models)
The Ice & Water Dispensing System can be
locked out to prevent unwanted use.

To Lock Out

 - Press the “Padlock” pad for 3-5

seconds. A RED light will appear above the
Padlock.

To Unlock

 - Press the “Padlock” pad for 3-5

seconds until the RED light above the Pad-
lock goes out.

ICE MAKER OPERATION

The ice maker is located behind the baffle in
the top of the freezer. The wire signal arm
may be raised up and locked in the “OFF”
position to stop ice maker operation (see
Figure 2). When the freezer temperature is
cold, the ice maker can be started by
lowering the wire signal arm to its “ON”
position.

Off

Apagado

Arrêt

Aus

Êëåéóôü

v£¹–îZ Úz

On

Encendido

Marche

Ein

Áíïéêôü

áø²¥šZ Úz

Figure 2
Figura 2
Figure 2
Abbildung 2

Ó÷Þìá

  2

2  á¼Ž

Wire Signal Arm

Señal de Alarma

Bras de coupure

Signalhebel

Âñá÷ßïíáòÓÞìáôïò

|f£ŽîZ oZfe

Ice & Water
Dispenser

WATER CONNECTION:

CAUTION:

 Ensure that the ice maker

water supply tube is connected to a safe
(potable) water pipe only.

CAUTION: 

Water supply must have a

minimum pressure of 1.4 bars (20 psi) and a
maximum pressure of 6.9 bars (100 psi).

DISPENSER LIGHT (SOME MODELS)

The light can be turned on and off by
pressing the light touchpad. The light will
illuminate the entire dispenser area. The
light also turns on automatically when the
ice and/or water is dispensed. If bulb
replacement is necessary, use an E14, 7 watt
appliance bulb.

OPERATION OF WATER DISPENSER

A water tank is located at the back of the
refrigerator compartment and holds about
0.7 liters (24 oz.) of water. As the water is
dispensed, the tank is automatically refilled.
When first installing the refrigerator, draw
and discard one glass of water. This action
will fill the tank and should take about 1½
minutes. Continue to draw and discard 7
more glasses of water to ensure that all
plumbing connections have been rinsed of
any impurities.

To ensure fresh tasting water, it is sug-
gested that the water dispenser be used
every day. If water supply is not used for
more than one week, flush the tank as
specified above.

NOTE

: The water delivery system has a

built-in shutoff device that will stop
thewater flow after 3 minutes of  continu-
ous use. To RESET the dispensing mecha-
nism, release the acuator button.

6

Summary of Contents for SANTO 7380KG

















Reviews: