g
14
0
Wait until the steam generator tem-
perature indication lamp in the base
extinguishes (approx. 3 minutes)
(fig.
9
).
0
Press steam jet button until steam
emerges (fig.
10
).
1
If there is no more water in the tank,
the steam jet button should no
longer be operated.
3
Owing to the high steam capacity, the
steam jet button need only be pressed
briefly each time. Short, repeated
pressing of the steam jet button is
enough to obtain a continuous and
sufficient amount of steam.
With intensive use steam can still be
emitted after releasing the steam jet
button and water can therefore con-
dense on the rest plate. If necessary,
dry the plate. There is no danger of
damage.
DBS 200 only: spray function
The articles for ironing can be mois-
tened using the spray function, e.g. to
remove severe creasing.
0
Keep the steam button pressed and
press the spray button throughout the
spraying time (fig.
11
).
The spray water mixes with the steam
and is emitted from the spray nozzle.
The moisture applied to the washing
articles is not always visible. It is suffi-
cient, however, to smooth folds and to
avoid excessively long drying times.
Steam regulator setting
(fig. 12)
Select the steam volume according to
the type and condition of the textiles:
very dry or damp textiles, textiles
which absorb water to a greater or
lesser degree.
DBS 200 only: TURBO-SHOT position
(fig. 2/R)
If the steam button is pressed, the iron
produces a strong jet of steam for sev-
eral seconds before the steam emission
is normal again. To produce this effect
again stop the steam output for a few
seconds and the special TURBO SHOT
system regulates the maximum steam
output without undesired emission of
water.
Refill with water
Water should be refilled as soon as the
level has fallen below the minimum
mark on the tank (fig.
4
).
3
The tank can also be refilled while iron-
ing. It is unnecessary to switch off the
appliance for this purpose.