Aeca Tarom MPPT 6000, Installation And Operating Instructions Manual

Page: 61 / 92

4.3.5 Connect the solar module
1. Safely cover the module (wind)
2. Connect the module cable with DC load circuit breaker to the solar module connection of the
controller and the solar module as follows:
n
A common DC load circuit breaker (in the common part of the module cable), when
1 solar module is connected in parallel to solar module inputs M1 and M2
n
Two separate DC load circuit breakers, when 2 solar modules are each separately con-
nected to solar module inputs M1 and M2 ; see Fig. 1, p. 8
3. Remove covers from the solar module.
4.3.6 Install lightning protection
Install suitable lightning protection.
4.4 Switch on the controller
✔
At least the battery and the solar module have been connected as described previously.
1. Fit the terminal cover so that the danger notice is legible (and not upside-down).
2. Fit the fastening screws.
3. Switch on the external battery fuse: Insert the fuse insert into the fuse holder (safety fuse) or
switch on the DC line circuit breaker . The controller automatically starts operating, displays
the company logo after a few seconds and then displays the detected system voltage in an
event message (
System voltage
xx V) or
RTC not set
(Fig. 3).
Note
English is set as the default menu language at the factory.
4. Press
sr
in order to display
System voltage
xx V. Note the displayed system voltage.
5. If additional event messages are displayed, or no messages are displayed (display dark), then
check the installation and if necessary correct the error using Ä
10, p. 31 onwards.
6. Press
ESC
to acknowledge the event message. The standard status display appears (Fig. 4).
7. Check that the noted system voltage corresponds to the actual battery voltage. If not, set the
system voltage in the expert menu (
Main menu
▶
Battery settings
▶
Expert menu
▶
System
voltage ; more information on this is provided in Ä
8.5, p. 26).
Fig. 3: Event message (English) with the detected system voltage (12 V in the example)
GB
749.126 | M02 | 2013-11-13 17