Aeca Tarom MPPT 6000, Installation And Operating Instructions Manual

Page: 75 / 92

10 Troubleshooting
Errors detected by the controller are indicated via event messages. With
Warning and Error events
the display blinks red. The list of event messages below contains information on troubleshooting
and fault correction.
10.1 Event messages
Indication on the display
2 3
25
4
6
1
①
Symbol for the type of event message:
Information, warning, error
②
Date/time at which the event occurred
③
Date/time at which the cause of the event message was cor-
rected
or
ACTIVE
, when the cause of the event message is still present.
④
Message text with error number
⑤
Counter:
No. of the displayed event message / Total number of
event messages
Max. number of event messages = 30
⑥
NEW indicates that the event messages has not yet been con-
firmed.
Function
Type Information (symbol ): A state or error exists that does not impair the functioning of the
device.
Type Warning (symbol ): An error exists that has caused the battery to be charged but the loads
are only supplied to a limited extent.
Type Error (symbol ): A serious error has occurred, due to which the correct functioning of the
device cannot be guaranteed
New event messages are displayed immediately. The messages disappear after they have been con-
firmed or their cause(s) have been corrected.
If messages exist whose cause has been corrected but have not been confirmed then * is shown in
the information bar of the status display.
If an already confirmed error recurs then it is displayed again.
Operation
Confirming event messages
✔
An event message with the comment
NEW
is displayed.
u Press ESC / r / s . The event message is confirmed.
Displaying event messages
✔
Main menu
▶
Event log
u Press rs to page through the event messages.
Clearing the event log
GB
749.126 | M02 | 2013-11-13 31